LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Vehicle Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the wiring harness electrical connector from the vehicle speed sensor.
    3. Fig 1: View Of VSS, Bolt & O-Ring Seal
    GM481937Courtesy of GENERAL MOTORS CORP.
  3. Remove the harness connector.
  4. Remove the bolt (2).
  5. Remove the vehicle speed sensor (1).
  6. Remove the O-ring seal (3).
scientia non olet · About LEMON Manuals