LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Transmission Fluid Filler Tube and Seal Replacement (2.9L and 3.7L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Filler Tube
    GM1302099Courtesy of GENERAL MOTORS CORP.
  1. Remove the filler tube indicator.
  2. Remove the nut (3) securing the filler tube to the secondary air injection (AIR) stud (2).
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Clean away all dirt and debris from the transmission filler tube area.
  5. Position an appropriate container under the transmission.
  6. Remove the filler tube (1) and seal (2) from the transmission.

    Allow the transmission fluid to drain into the container.

scientia non olet · About LEMON Manuals