LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Transmission Fluid Filler Tube and Seal Replacement (2.9L and 3.7L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Filler Tube & Seal
    GM744703Courtesy of GENERAL MOTORS CORP.
  1. Install a new seal (2) into the transmission case.
  2. Remove the container used to catch the used transmission fluid from under the vehicle.
  3. Lightly lubricate the filler tube (1) and seal (2) with clean DEXRON® VI transmission fluid to ease installation.
  4. Install the filler tube (1) into the seal (2).
  5. Lower the vehicle.
    6. Fig 2: View Of Filler Tube
    GM1302099Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Install the nut (3) securing the filler tube (1) to the AIR stud (2).

    Tighten:  Tighten the filler tube nut to 12.5 N.m (111 lb in).

  7. Install the filler tube indicator.
  8. Fill the transmission to the proper level with DEXRON® VI transmission fluid. Refer to Transmission Fluid Check .
scientia non olet · About LEMON Manuals