LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the vehicle is in the park position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: View Of Range Selector Cable & Components
    GM1302081Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not pull on the boot portion of the cable.
  3. Complete the following in order to disconnect the range selector cable (3) from the transmission range selector lever ball stud.
    1. Insert a flat bladed tool between the range selector cable end (5) and the range selector lever (1).
    2. Pry the range selector cable end (5) away from the range selector lever (1).
  4. Remove the retainer (4) from the range selector cable (3).
  5. Push the range selector cable locking tabs inward toward each other to release from the bracket (2).
    6. Fig 2: View Of Cable Grommet & Floor Panel
    GM1302083Courtesy of GENERAL MOTORS CORP.
  6. Push the cable grommet (1) up through the floor panel (2).
  7. Lower the vehicle.
  8. Remove the left hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side .
  9. Pull the drivers side carpet up, enough to access the range selector cable.
    10. Fig 3: Locating Range Selector Cable Retainer At Lower Dash Panel
    GM1302084Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the range selector cable retainer (2) from the lower dash panel (1).
    11. Fig 4: View Of Range Selector Cable & Steering Column Bracket
    GM1302085Courtesy of GENERAL MOTORS CORP.
  11. Complete the following in order to disconnect the range selector cable (4) from the transmission range selector lever ball stud (1).
    1. Insert a flat bladed tool between the range selector cable end (2) and the range selector lever.
    2. Pry the range selector cable end (2) away from the range selector lever.
  12. Remove the retainer (3) from the range selector cable (4).
  13. Push the range selector cable locking tabs inward toward each other to release from the steering column bracket (5).
  14. Remove the range selector cable (4) from the vehicle.
scientia non olet · About LEMON Manuals