LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Range Selector Lever Cable Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the vehicle is in the PARK position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Fig 1: View Of Range Selector Cable & Components
    GM1302081Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not pull on the boot portion of the cable.
  4. Complete the following in order to disconnect the range selector cable (3) from the transmission range selector lever ball stud.
    1. Insert a flat-bladed tool between the range selector cable end (5) and the range selector lever (1).
    2. Pry the range selector cable end (5) away from the range selector lever (1).
  5. Remove the retainer (4) from the range selector cable (3).
  6. Push the range selector cable locking tabs inward toward each other to release from the bracket (2).
  7. Fig 2: View Of Fuel Hose/Pipe Bracket & Nuts (M30)
    GM1350750Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the fuel hose/pipe retainer (4) from the range selector cable bracket (3).
  9. Fig 3: View Of Transmission Vent Hose & Retainers
    GM1302098Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the transmission vent hose retainer (6) from the range selector cable bracket.
  11. Fig 4: View Of Transmission Range Selector Cable Bracket
    GM1302087Courtesy of GENERAL MOTORS CORP.
  12. Remove the bolts securing the transmission range selector cable bracket to the transmission.
  13. Remove the transmission range selector cable bracket from the transmission.