LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Manual Shift Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the park/neutral back up switch. Refer to Park/Neutral Position and Backup Lamp Switch Replacement .
    2. Fig 1: Sliding Seal Remover Tool Over Selector Shaft
    GM659335Courtesy of GENERAL MOTORS CORP.
  2. Be sure that the jackscrew for the J 43911  is backed off and will not interfere with installation of the removal tool. See Special Tools . Slide the seal remover tool over the selector shaft (2) with the threaded end of the tool towards the seal.
  3. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool is firmly attached to the seal shell.
  4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
scientia non olet · About LEMON Manuals