LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> Turbine Shaft Seal Installation >> Installation

Turbine Shaft Seal Installation: Installation

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Turbine Shaft Oil Seal Rings
    GM1601754Courtesy of GENERAL MOTORS CORP.
  1. Use the J 36418-1B  (1) in order to install the four turbine shaft oil seal rings (619). See Special Tools .
  2. Resize oil seal rings (619) after installation:
    1. Place J 36418-2A  (2) over the turbine shaft oil seal rings (619) and seat against input housing. See Special Tools .
    2. Remove J 36418-2A  (2). See Special Tools .
    3. Turn J 36418-2A  (2) upside down and place over the turbine shaft oil seal ring (619). See Special Tools .
    4. Seat against input housing.
    5. Leave J 36418-2A  (2) in place over the turbine shaft oil seal rings (619) until the reverse input clutch housing is installed. See Special Tools .
scientia non olet · About LEMON Manuals