LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> Transmission Fluid Pan Installation

Transmission Fluid Pan Installation

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Oil Pan & Gasket
    GM1265865Courtesy of GENERAL MOTORS CORP.
  1. Place the transmission oil pan gasket (73) on the case.
  2. Place the transmission oil pan (75) on the case.
    3. NOTE: Refer to Fastener Notice .
  3. Install all of the transmission oil pan screws (76).

    Tighten:  Tighten the screws to 16 N.m (11.8 lb ft).

scientia non olet · About LEMON Manuals