Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 8092 Universal Driver Handle - 3/4 in - 10
J 7004-A Universal Remover. See Special Tools .
J 23907 Slide Hammer with Bearing Adapter. See Special Tools .
J 25019-14 Stator Pump Bushing Remover. See Special Tools .
J 29369-2 Bushing and Bearing Remover 2-3 in. See Special Tools .
J 34196-B Transmission Bushing Service Set. See Special Tools .

Fig 1: Identifying Reaction Carrier Components

Courtesy of GENERAL MOTORS CORP.

Remove the reaction carrier shaft/internal gear retainer (668) and the reaction carrier shaft (666) from the input internal gear (664).
Inspect the reaction carrier shaft (666) and the input internal gear (664) for the following defects:
- Scoring
- Cracking
- Damaged or worn bushings
- A cracked shaft
- A damaged spline
- Damaged gear teeth

Fig 2: Removing Reaction Carrier Shaft Front Bushing

Courtesy of GENERAL MOTORS CORP.

UsingJ 29369-2 with J 23907 , remove the reaction carrier shaft front bushing (665). See Special Tools .

Fig 3: Using J 25019-14 & J 25019-14 To Remove Reaction Carrier Shaft Rear Bushing

Courtesy of GENERAL MOTORS CORP.

UsingJ 25019-14 with J 7004-A , remove the reaction carrier shaft rear bushing (667). See Special Tools .