Tools Required

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

J 29837-A Output Shaft Support Fixture. See Special Tools .

Fig 1: View Of Output Shaft

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: It is important to note that the input shaft may need a light tap to fully seat into position. If the input shaft is not completely engaged, the output shaft to input carrier retainer (661) will not seat.

Install the output shaft (687).

Fig 2: Identifying Special Tool J29837-A & Output Shaft O-Ring Seal

Courtesy of GENERAL MOTORS CORP.

Install the J 29837-A as shown. See Special Tools . Support the output shaft (687) with adjustable stop (1).