LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> Input Speed Sensor Removal

Input Speed Sensor Removal

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Speed Sensor (ISS) Retaining Bolt
    GM1552933Courtesy of GENERAL MOTORS CORP.
  1. Remove the input speed sensor (ISS) retaining bolt (247).
  2. Use a small tipped screwdriver to carefully pry the ISS wiring harness retaining brackets from the pump housing. Being careful not to damage retainer clips.
  3. Remove the ISS assembly (250).
scientia non olet · About LEMON Manuals