LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> 1-2 Accumulator Disassemble

1-2 Accumulator Disassemble

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Using Air To Clean Accumulator Housing
    GM1755945Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Some models may not use an outer 1-2 accumulator spring (54).
  1. Blow air into the 1-2 accumulator housing (57) to remove the 1-2 accumulator piston (56).
  2. Remove the 1-2 inner (104) and outer (54) accumulator springs.
scientia non olet · About LEMON Manuals