LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 201 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (Rear Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission mount support assembly to the vehicle.
    2. Fig 1: View Of Transmission Mounting Bolts
    GM1649726Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the transmission mount support to transmission mounting bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

  3. Install the transmission mount support to body mounting bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

    4. Fig 2: View Of Transmission Mount Assembly Components
    GM1850370Courtesy of GENERAL MOTORS CORP.
  4. Install the transmission vent hose to the retainers (6) on the mount assembly.
  5. Remove the transmission jack.
  6. Install the exhaust system.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals