LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 201 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Engine Oil and Transmission Fluid Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cooler Retainer Clips
    GM1704897Courtesy of GENERAL MOTORS CORP.
  1. Install the cooler.
    2. NOTE: Refer to Fastener Notice .
  2. Install the cooler mounting bolts.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

  3. Connect the EOC lines to the cooler.
  4. Connect the EOC lines to the EOC retaining clips.
  5. Connect the TOC lines to the TOC.
  6. Connect the TOC line to the TOC retainer clip.
  7. Reposition and install the condenser. Refer to Condenser Replacement (Standard Cooling) or Condenser Replacement (Heavy Duty Cooling) .
scientia non olet · About LEMON Manuals