Radio Replacement

Fig 1: Radio Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument panel center trim panel. Refer to Instrument Panel Center Trim Panel Replacement (Left Hand Drive) or Instrument Panel Center Trim Panel Replacement (Right Hand Drive) .
1	Radio Screw (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2.5 N.m (22 lb in)
2	Radio Assembly Procedure Disconnect the electrical connector. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References . Tip: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

Callout

Component Name

Radio Screw (Qty: 4)

NOTE: Refer to Fastener Notice .

Tighten: 2.5 N.m (22 lb in)

Radio Assembly

Procedure

Tip: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.