LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Replacement (5.3L) >> Disassembling Cable

Disassembling Cable

  1. Set the parking brake.
  2. Ensure that the shift control lever is in the park (P) position.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    4. Fig 1: Spring Loaded Cover & Cable Adjustment Lock
    GM1524267Courtesy of GENERAL MOTORS CORP.
  4. Pull back the spring loaded cover (2) to expose the cable adjustment lock (3).
    5. Fig 2: Cable Adjustment Lock
    GM1524268Courtesy of GENERAL MOTORS CORP.
  5. Lift the cable adjustment lock (3) up to unlock both halves of the range selector cable (1, 4).
    6. Fig 3: Range Selector Cable
    GM1524270Courtesy of GENERAL MOTORS CORP.
  6. Rotate the range selector cable to expose the retaining clip (5).

    It may be necessary to pull the transaxle end of the range selector cable (4) out of the shift control end of the range selector cable (1) to fully expose the retaining clip (5).

    7. Fig 4: Retaining Clip & Shift Control Cable
    GM1524271Courtesy of GENERAL MOTORS CORP.
  7. Remove the retaining clip (2) from the range selector cable (3).
    8. Fig 5: Shift Control Cable & Transmission Cable
    GM1900890Courtesy of GENERAL MOTORS CORP.
  8. Separate the shift control end of the cable (1) from the transmission end of the cable (2).
scientia non olet · About LEMON Manuals