LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Replacement (5.3L) >> Cable Removal - Transmission End

Cable Removal - Transmission End

    Fig 1: Shift Control Cable & Transmission Cable
    GM1900890Courtesy of GENERAL MOTORS CORP.

  1. Remove the range selector cable retainer (3) from the frame.

  2. Remove the range selector cable retainer (4) from the transfer case.
    3. Fig 2: Heat Shield Bolts
    GM1900888Courtesy of GENERAL MOTORS CORP.
  3. Remove the heat shield bolts (1).
  4. Remove the heat shield (2).
    5. Fig 3: Range Selector Cable &Range Selector Lever
    GM1900891Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not pull on the boot portion of the cable.
  5. Disconnect the range selector cable end (3) from the range selector lever.
  6. Remove the retainer (1) from the range selector cable (2).
  7. Push the range selector cable locking tabs (2) inward toward each other to release the cable from the bracket.
scientia non olet · About LEMON Manuals