LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Bracket Replacement (5.3L) >> Removal Procedure

Removal Procedure

  1. Ensure the vehicle is in the PARK position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Transmission Vent Hose Retainer
    GM1912460Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the transmission vent hose retainer (4) from the transmission range selector cable bracket.
    4. Fig 2: Heat Shield Bolts
    GM1900888Courtesy of GENERAL MOTORS CORP.
  4. Remove the heat shield bolts (1).
  5. Remove the heat shield (2).
    6. Fig 3: Range Selector Cable & Range Selector Cable Bracket
    GM1900891Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not pull on the boot portion of the cable.
  6. Disconnect the range selector cable end (3) from the range selector lever.
  7. Remove the retainer (1) from the range selector cable (2).
  8. Push the range selector cable locking tabs (2) inward toward each other to release the cable from the bracket.
    9. Fig 4: View Of Transmission Range Selector Cable Bracket
    GM1302087Courtesy of GENERAL MOTORS CORP.
  9. Remove the bolts securing the transmission range selector cable bracket to the transmission.
  10. Remove the transmission range selector cable bracket from the transmission.
scientia non olet · About LEMON Manuals