LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Bracket Replacement (5.3L) >> Installation Procedure

Installation Procedure

    Fig 1: Transmission Range Selector Cable Bracket
    GM1302087Courtesy of GENERAL MOTORS CORP.
  1. Position the transmission range selector cable bracket to the transmission.
    2. NOTE: Refer to Fastener Notice .
  2. Install the transmission range selector cable bracket bolts.

    Tighten:  Tighten the transmission range selector cable bracket bolts to 25 N.m (18 lb ft).

    3. Fig 2: Range Selector Cable & Range Selector Cable Bracket
    GM1900891Courtesy of GENERAL MOTORS CORP.
  3. Install the range selector cable (2) to the range selector cable bracket. Ensure the range selector cable retaining tabs fully engage the range selector cable bracket.
  4. Install the retainer (1) to the range selector cable (2).
  5. Connect the range selector cable end (3) to the transaxle range switch lever.
    6. Fig 3: Heat Shield Bolts
    GM1900888Courtesy of GENERAL MOTORS CORP.
  6. Install the heat shield (2).
  7. Install the heat shield bolts (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    8. Fig 4: Transmission Vent Hose Retainer
    GM1912460Courtesy of GENERAL MOTORS CORP.
  8. Connect the transmission vent hose retainer (4) to the transmission range selector cable bracket.
  9. Adjust the automatic transmission range selector cable. Refer to Range Selector Lever Cable Adjustment (3.7L)  or Range Selector Lever Cable Adjustment (5.3L) .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals