LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Bracket Replacement (3.7L) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Transmission Range Selector Cable Bracket
    GM1302087Courtesy of GENERAL MOTORS CORP.
  1. Position the transmission range selector cable bracket to the transmission.
    2. NOTE: Refer to Fastener Notice .
  2. Install the transmission range selector cable bracket bolts.

    Tighten:  Tighten the transmission range selector cable bracket bolts to 25 N.m (18 lb ft).

    3. Fig 2: View Of Fuel Hose/Pipe Bracket & Nuts (M30)
    GM1350750Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel hose/pipe retainer (4) to the range selector cable bracket (3).
    4. Fig 3: Transmission Vent Hose & Retainers
    GM1302098Courtesy of GENERAL MOTORS CORP.
  4. Connect the transmission vent hose retainer (6) to the range selector cable bracket.
    5. Fig 4: Range Selector Cable & Components
    GM1302081Courtesy of GENERAL MOTORS CORP.
  5. Install the range selector cable (3) to the bracket (2).
  6. Install the retainer (4) to the range selector cable (3).
  7. Adjust the automatic transmission range selector cable. Refer to Range Selector Lever Cable Adjustment (3.7L)  or Range Selector Lever Cable Adjustment (5.3L) .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals