LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Adjustment (5.3L) >> Adjustment Procedure

Adjustment Procedure

  1. Ensure that the shift control is in the park (P) position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Ensure that the range selector cable is not restricted.
    4. Fig 1: View Of White Plastic Cover On Center Connector
    GM466176Courtesy of GENERAL MOTORS CORP.
  4. Pull back the plastic cover (1) on the center connector.
    5. Fig 2: Locating Lock Button Center Tabs
    GM466195Courtesy of GENERAL MOTORS CORP.
  5. Pull up on the center tabs of the lock button (2).
    6. Fig 3: Shift Cable Components
    GM466226Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: This step must be performed correctly to avoid a misadjusted cable. Do not grasp the shift cable end (2) during this procedure.
  6. Release the shift cable end (2) and allow the spring to tension/adjust the shift cable system.
  7. Pull the cover (3) on the shift cable end (1) back.
    8. Fig 4: Engaging Locking Teeth On Shift Cable End
    GM466228Courtesy of GENERAL MOTORS CORP.
  8. Push the lock button (2) down to engage the locking teeth on the shift cable end (1).
    9. Fig 5: Locating White Cover
    GM466230Courtesy of GENERAL MOTORS CORP.
  9. Release the cover (1).
    10. Fig 6: View Of White Cover & Natural Colored Lock
    GM466234Courtesy of GENERAL MOTORS CORP.
  10. Verify the cover (1) conceals the lock (2).
  11. If the cover (1) does not conceal the lock (2), the shift cable must be readjusted.
  12. Lower the vehicle.
  13. Check the vehicle for proper operation.
scientia non olet · About LEMON Manuals