LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Park/Neutral Position and Backup Lamp Switch Replacement (5.3L) >> Removal Procedure

Removal Procedure

  1. Apply the parking brake.
  2. Shift the transmission into NEUTRAL.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the left catalytic converter. Refer to Catalytic Converter Replacement - Left Side (LH8) .
  5. Fig 1: Heat Shield Bolts
    GM1900888Courtesy of GENERAL MOTORS CORP.
  6. Remove the heat shield bolts (1).
  7. Remove the heat shield (2).
  8. Fig 2: Range Selector Cable & Range Selector Cable Bracket
    GM1900891Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not pull on the boot portion of the cable.
  9. Disconnect the range selector cable end (3) from the range selector lever.
  10. Remove the retainer (1) from the range selector cable (2).
  11. Push the range selector cable locking tabs (2) inward toward each other to release the cable from the bracket.
  12. Fig 3: View Of Transmission Control Lever
    GM1302094Courtesy of GENERAL MOTORS CORP.
  13. Remove the nut securing the transmission control lever to the manual shaft.
  14. Remove the transmission control lever from the manual shaft.
  15. Fig 4: View Of Park/Neutral Back Up Switch Electrical Connector
    GM1302100Courtesy of GENERAL MOTORS CORP.
  16. Disconnect the electrical connector (3) from the switch (4).
  17. Fig 5: View Of Park/Neutral Back Up Switch
    GM1302093Courtesy of GENERAL MOTORS CORP.
  18. Remove the bolts securing the park/neutral back up switch to the transmission.
  19. IMPORTANT: If the switch does not slide off the manual shaft, the outer edge of the manual shift shaft may need to be filed to remove any burrs.
  20. Remove the park/neutral back up switch from the manual shaft.