Park/Neutral Position and Backup Lamp Switch Adjustment

IMPORTANT:

The following procedure is for vehicles that have not had the switch removed or replaced. If the switch has been removed or replaced, refer to Park/Neutral Position and Backup Lamp Switch Replacement (3.7L) or Park/Neutral Position and Backup Lamp Switch Replacement (5.3L) for the proper adjustment procedure.
Apply the parking brake.
The engine must start in the P (PARK) or N (NEUTRAL) positions only.
Check the switch for proper operation. If adjustment is required, proceed as follows:

Place the transmission range selector in the N (NEUTRAL) position.
With an assistant in the drivers seat, raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Loosen the park/neutral position switch mounting bolts.
With the vehicle in the N (NEUTRAL) position, rotate the switch while the assistant attempts to start the engine.
Following a successful start, turn the engine OFF.

NOTE: Refer to Fastener Notice .

Tighten the bolts securing the park/neutral back up switch to the transmission.
Tighten: Tighten the park/neutral back up switch bolts to 27 N.m (20 lb ft).
Lower the vehicle.
Check the switch for proper operation. The engine must start in the P (PARK) or N (NEUTRAL) positions only.
Replace the park/neutral position switch if proper operation can not be achieved. Refer to Park/Neutral Position and Backup Lamp Switch Replacement (3.7L) or Park/Neutral Position and Backup Lamp Switch Replacement (5.3L) .