Removal Procedure

Tools Required

• J 25019  Bushing Service Set. See Special Tools .
• J 34196-B  Transmission Bushing Service Set. See Special Tools .
• J 7004-A  Universal Remover. See Special Tools .
• J 8092  Driver Handle

Fig 1: View Of Reverse Input Clutch Housing & Drum Assembly
Courtesy of GENERAL MOTORS CORP.
1. Inspect the reverse input clutch housing and drum assembly for the following conditions:
   • Damaged or worn bushings
   • Surface finish on the hub and outer housing - check band surface for flatness
   • Leak at the weld
   • Heat distortion
   • Rolled or distorted retaining ring groove
Fig 2: Identifying Reverse Input Clutch Front Bushing
Courtesy of GENERAL MOTORS CORP.
2. Using the J 25019-16  with the J 7004-A  , remove the reverse input clutch front bushing (603). See Special Tools .
Fig 3: Locating Reverse Input Clutch Rear Bushing
Courtesy of GENERAL MOTORS CORP.
3. Using the J 25019-4  with the J 8092  , remove the reverse input clutch rear bushing (606).