LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Off-Vehicle Repair Instructions >> Oil Pump Removal >> Removal

Oil Pump Removal: Removal

    Fig 1: Locating Pump Bolts & Seals
    GM1730033Courtesy of GENERAL MOTORS CORP.
  1. Remove all pump bolts (2) and pump bolt seal (3).
  2. Install J 45053  over stator shaft. See Special Tools . Tighten the clamp bolts (1).
  3. To prevent slipping, securely fasten the J 45053  around the stator shaft by tightening the bolts (1) with a wrench. See Special Tools .
    4. Fig 2: Locating Pump Assembly
    GM1730035Courtesy of GENERAL MOTORS CORP.
  4. Turn the T-handle of the J 45053  to pull the pump assembly (4) from the case. See Special Tools .
  5. Lift the pump (4) out of the case.
    6. Fig 3: View Of Fluid Pump Seal & Gasket
    GM1552919Courtesy of GENERAL MOTORS CORP.
  6. Remove the fluid pump seal (5).
  7. Remove the pump cover to case gasket (6).
scientia non olet · About LEMON Manuals