LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Off-Vehicle Repair Instructions >> Oil Pump Cover and Body Assemble >> Assemble

Oil Pump Cover and Body Assemble: Assemble

    Fig 1: Identifying Pump Cover Bolts
    GM1552936Courtesy of GENERAL MOTORS CORP.
  1. Place the oil pump cover onto the oil pump body and put stator shaft through a hole in the bench.
  2. Install the pump cover bolts (233) finger tight only.
    3. Fig 2: Identifying Pump Cover Bolts
    GM1552965Courtesy of GENERAL MOTORS CORP.
  3. Install the J 21368  . See Special Tools .
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the pump cover bolts (233).

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

  5. Remove the J 21368  . See Special Tools .
scientia non olet · About LEMON Manuals