LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Off-Vehicle Repair Instructions >> Low and Reverse Clutch Piston Removal >> Removal

Low and Reverse Clutch Piston Removal: Removal

    Fig 1: J 23327-1 & J 42628
    GM190454Courtesy of GENERAL MOTORS CORP.
  1. Install the J 23327-1  and the J-42628  . See Special Tools .
    2. Fig 2: View Of Low And Reverse Clutch Spring Assembly & Retainer Ring
    GM59269Courtesy of GENERAL MOTORS CORP.
  2. Tighten the J 23327-1  . See Special Tools .
  3. Remove the low and reverse clutch retainer ring (693) using the J 34627  . See Special Tools .
  4. Remove the low and reverse clutch spring assembly (694).
    5. Fig 3: Blowing Air Into Case Passage
    GM4190Courtesy of GENERAL MOTORS CORP.
  5. Blow compressed air into the case passage to remove the low and reverse clutch piston (695).
    • (1) LO Feed Passage
    • (2) REV Feed Passage
scientia non olet · About LEMON Manuals