LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Off-Vehicle Repair Instructions >> Low and Reverse Clutch Piston Installation >> Installation Procedure

Installation Procedure

    Fig 1: Transmission Seals Onto Low And Reverse Clutch Piston
    GM5708Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission (low and reverse clutch outer, center, inner) seals (696) on the low and reverse clutch piston (695).
  2. Lubricate the seals with assembly lubricant J 36850  or an equivalent.
    3. Fig 2: Aligning Parking Brake Pawl Window With Notch In Piston
    GM5498Courtesy of GENERAL MOTORS CORP.
  3. Install the low and reverse clutch piston (695) into the case. The notch in the piston must be aligned with the parking brake pawl window, in the case.
    4. Fig 3: View Of Low And Reverse Clutch Spring Assembly & Retainer Ring
    GM59269Courtesy of GENERAL MOTORS CORP.
  4. Install the low and reverse clutch spring assembly (694).
    1. Using the J 23327-1  , compress the low and reverse clutch spring assembly (694). See Special Tools .
    2. Using J 36850  install the low and reverse clutch retainer ring (693).
scientia non olet · About LEMON Manuals