LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Off-Vehicle Repair Instructions >> 2-4 Band Servo Piston Pin Length Check >> Check

2-4 Band Servo Piston Pin Length Check: Check

    Fig 1: 2-4 Servo Assembly
    GM5430Courtesy of GENERAL MOTORS CORP.
  1. Disassemble the 2-4 servo assembly. If necessary, refer to 2-4 Band Servo 2nd Apply Piston Disassemble .
    2. Fig 2: Locating Servo Cover Retaining Ring
    GM7756Courtesy of GENERAL MOTORS CORP.
  2. Install the band apply pin (13) and the J 33037  (1). See Special Tools .
  3. Install the servo cover retaining ring (29) to secure the tool.
    4. Fig 3: Identifying Gage Slot
    GM7757Courtesy of GENERAL MOTORS CORP.
  4. Apply 11 N.m (98 lb in) torque. If the white line appears in the gage slot (1), the pin length is correct.
  5. If a new pin is needed, refer to 2-4 Band Servo Piston Pin Selection in order to determine correct pin length.


    Fig 1: Locating Servo Cover Retaining Ring
    GM7756Courtesy of GENERAL MOTORS CORP.
  1. Install the band apply pin (13) and the J 33037  . See Special Tools .
  2. Install the servo cover retaining ring (29) to secure the tool.
    3. Fig 2: Identifying Gage Slot
    GM7757Courtesy of GENERAL MOTORS CORP.
  3. Apply 11 N.m (98 lb in) torque. If the white line appears in the gage slot (1), the pin length is correct.
  4. If a new pin is needed, refer to 2-4 Band Servo Piston Pin Selection in order to determine the correct pin length.
scientia non olet · About LEMON Manuals