LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Off-Vehicle Repair Instructions >> 1-2 Accumulator Installation >> Installation

1-2 Accumulator Installation: Installation

    Fig 1: Valve Body Bonded Spacer Plate
    GM1890050Courtesy of GENERAL MOTORS CORP.
  1. Inspect the valve body bonded spacer plate for damage or debris.
    2. Fig 2: Locating #1 Checkball
    GM5455Courtesy of GENERAL MOTORS CORP.
  2. Install the number 1 checkball into the case.
    3. Fig 3: Valve Body Bonded Spacer Plate
    GM1887602Courtesy of GENERAL MOTORS CORP.
  3. Install the J 25025-5  into the case. See Special Tools .
    4. IMPORTANT: Do not reuse the bonded spacer plate. Replace with a NEW bonded spacer plate.
  4. Place the bonded spacer plate on the case.
    5. Fig 4: View Of Spacer Plate Support Plate & Bolts
    GM1283236Courtesy of GENERAL MOTORS CORP.
  5. Install the spacer plate support plate (53 or 113).
  6. Install the spacer plate support bolts (77).
    7. NOTE: Refer to Fastener Notice .
  7. Install the accumulator bolt (115), model dependent.

    Tighten:  Tighten the accumulator bolt to 11 N.m (8.11 lb ft).

    8. Fig 5: 1-2 Accumulator Housing Bolts
    GM1283239Courtesy of GENERAL MOTORS CORP.
  8. Install the 1-2 accumulator housing assembly (57) or gasket (114) and housing (116).
  9. Install the 1-2 accumulator housing bolts (58, 59 or 117, 118).

    Tighten: 

    • Tighten the bolts 58 and 59 to 11 N.m (8 lb ft).
    • Tighten the bolts 117 and 118 to 8-14 N.m (6-10 lb ft).

scientia non olet · About LEMON Manuals