LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Power Brake Booster Outlet Front Pipe Replacement >> Removal Procedure

Removal Procedure

CAUTION: Refer to Brake Fluid Irritant Caution .
  1. Remove the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (LHD) or Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (RHD) .
  2. Install the CH-47830  to the master cylinder assembly.
  3. Position the CH-47830  with the master cylinder assembly in a vise.
    4. Fig 1: Brake Booster Inlet/Outlet Pipes
    GM1618574Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the power brake booster outlet pipe fittings (1).
  5. Remove the power brake booster outlet pipe (2) from the hydraulic brake booster pump (3) and the master cylinder (4).
scientia non olet · About LEMON Manuals