LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Master Cylinder Reservoir Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Master Cylinder Reservoir & Attachments
    GM1749133Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply a small amount of CLEAN brake fluid to the grommets before installation.
  1. Install the grommets (4) and (5), if removed.
  2. Install the master cylinder reservoir (3).
  3. Install the master cylinder reservoir roll pin (2).
  4. Install the fluid level sensor electrical connector (6) to the bracket.
    5. NOTE: Refer to Fastener Notice .
  5. Install the master cylinder reservoir bolt (1).

    Tighten:  Tighten the bolt to 2 N.m (18 lb in).

  6. Remove the brake master cylinder from the CH-47830  .
  7. Install the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (LHD) or Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (RHD) .
  8. Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling (with RPO BRM)  or Master Cylinder Reservoir Filling (without RPO BRM) .
scientia non olet · About LEMON Manuals