Idler Pulley: Service and Repair

Drive Belt Idler Pulley Replacement

Removal Procedure





1. Loosen the drive belt idler pulley bolt.
2. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory (Drive Belt Replacement - Accessory) .
3. Remove the drive belt idler pulley and bolt.



Installation Procedure





1. Install the drive belt idler pulley and bolt to the generator bracket.
Snug the bolt finger tight.
2. Install the drive belt. Refer to Drive Belt Replacement - Accessory (Drive Belt Replacement - Accessory) .
Notice: Refer to Fastener Notice .


3. Tighten the drive belt idler pulley bolt.

Tighten the drive belt idler pulley bolt to 50 N.m (37 lb ft).