LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Transmission >> Transfer Case - BW 4484 >> Repair Instructions - On Vehicle >> Transfer Case Fluid Replacement >> Removal Procedure

Removal Procedure

IMPORTANT: When performing the following service procedures, use only hand tools to remove and install the fill or drain plugs.
    Fig 1: Transfer Case Drain Plug
    GM860426Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the fill plug from the transfer case.
    3. IMPORTANT: When draining the transfer case, make sure that an approved drain pan is used.
  3. Remove the drain plug from the transfer case.
scientia non olet · About LEMON Manuals