LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Transmission >> Transfer Case - BW 4484 >> Repair Instructions - On Vehicle >> Rear Output Shaft Seal Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing Rear Output Shaft Seal
    GM819580Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
  3. Remove the rear output shaft seal by prying it out with a flat-tipped screwdriver.
scientia non olet · About LEMON Manuals