Circuit/System Testing

Ensure the TFT is near the temperature displayed in the Failure Records.
Start the engine and place the transmission range selector in D6.
Observe the TFP Switch 5 parameter while commanding 1st gear and then commanding 2nd gear with the scan tool. The TFP switch 5 should transition from low in 1st gear to high in 2nd gear.
- If the TFP Switch 5 parameter state does not change, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
- If no concerns are found, replace the control solenoid (w/body and TCM) valve assembly.