Conditions for Running the DTC

Condition 1

No DTCs P0711, P0716, P0717, P0722, or P0723.
DTC P0711 not passed this key ON.
Ignition voltage is between 8.6-18.0 volts.
The engine coolant temperature (ECT) is valid.
The TCM internal temperature is -49°C to +169°C (-56°F and +336°F).
The engine speed is 500-7500 RPM for at least 5 seconds.
The vehicle speed is greater than 8 km/h (5 mph) for 300 seconds cumulative.
TCC slip speed is greater than 120 RPM for 300 seconds cumulative.
The TFT is between -40°C and +21°C (-40°F and +70°F).
The TFT has changed by less than 2.0°C (3.6°F) in 100 seconds.
The ECT is greater than 70°C (158°F).
The ECT has increased by 55°C (99°F) since startup.
The TCM TFT sensor is between -50°C and +169°C (-58°F and +336°F) at start up.

Condition 2

No DTCs P0711, P0716, P0717, P0722, or P0723.
DTC P0711 not passed this key ON.
Ignition voltage is between 8.6-18.0 volts.
The ECT is valid.
The TCM internal temperature is -49°C to +169°C (-56°F and +336°F).
The engine speed is 500-7500 RPM for at least 5 seconds.
The vehicle speed is greater than 8 km/h (5 mph) for 300 seconds cumulative.
The ECT is greater than 70°C (158°F).
The ECT has increased by 55°C (99°F) since startup.
The TCM TFT sensor is between 129-170°C (264-338°F) at start up.

Condition 3

Ignition voltage is between 8.6-18.0 volts.
The engine speed is 500-7500 RPM for at least 5 seconds.

Condition 4

No DTCs P0711, P0716, P0717, P0722, or P0723.
DTC P0711 not passed this key ON.
Ignition voltage is between 8.6-18.0 volts.
The ECT is valid.
The ECT is between -39°C and +149°C (-36°F and +300°F).
The TCM internal temperature is -49°C to +169°C (-56°F and +336°F).
Accelerator pedal position signal is valid.
Accelerator pedal position is between 8-100 percent.
The engine speed is 500-7500 RPM for at least 5 seconds.
The TCM must receive a valid torque signal from the ECM.
Engine torque is between 50-1492 N.m (36-1100 lb ft).
Vehicle speed is between 8-511 km/h (5-317 mph).
No transmission shift default actions active.