LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tires And Wheels >> Repair Instructions >> Spare Tire Carrier Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Spare Tire Carrier Assembly
    GM1455917Courtesy of GENERAL MOTORS CORP.
  1. Install the spare tire carrier to the vehicle. Perform the following steps:
    1. Position the spare tire carrier to the rear bumper.
    2. Loose install the carrier bolts. Refer to Service Alignment Procedure .
    3. Connect the license plate lamp harness electrical connector.
    2. Fig 2: Removing/Installing Spare Tire
    GM1455916Courtesy of GENERAL MOTORS CORP.
  2. Install the spare tire to the spare tire carrier.
  3. Install the spare tire mounting nuts.

    Tighten:  Tighten the nuts to 95 N.m (70 lb ft).

    4. Fig 3: Spare Tire Components
    GM1455913Courtesy of GENERAL MOTORS CORP.
  4. Install the spare tire cover (2).
  5. Install the spare tire stowage cover nut (1) until snug.
  6. Close and ensure that the spare tire carrier is latched.
scientia non olet · About LEMON Manuals