LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tires And Wheels >> Repair Instructions >> Spare Tire Carrier Replacement >> Assembly Procedure

Assembly Procedure

    Fig 1: Latch Mechanism & Related Components
    GM1504086Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Thoroughly clean the latch casting surfaces and bond the NEW isolator in place using LOCTITE Black Max 380® adhesive or equivalent.
  1. Install the latch mechanism isolator, if necessary.
  2. Install the latch mechanism isolator screws.

    Tighten:  Tighten the screws to 9 N.m (80 lb in).

  3. Install the latch mechanism, if necessary.
  4. Install the latch mechanism bolts, spacers, and nuts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    5. Fig 2: Striker Bolt And Sleeve
    GM1504082Courtesy of GENERAL MOTORS CORP.
  5. Install the sleeve and striker bolt, if necessary.

    Tighten:  Tighten the bolt to 22 N.m (16 lb ft).

    6. Fig 3: Spare Tire Carrier Swing Arm
    GM1504080Courtesy of GENERAL MOTORS CORP.
  6. Install the spare tire carrier swing arm to the hinge, if necessary.
    7. Fig 4: License Plate Lamp Harness
    GM1504078Courtesy of GENERAL MOTORS CORP.
  7. Install the license plate lamp harness, if necessary.
  8. Install the license plate lamp harness to the clips on the carrier.
    9. Fig 5: License Plate Lamp Screws
    GM1504075Courtesy of GENERAL MOTORS CORP.
  9. Install the license plate lamp screws, if necessary.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals