LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension General Diagnosis >> Diagnostic Information and Procedures >> Trim Height Inspection >> Z Height Adjustment

Z Height Adjustment

    Fig 1: Adjusting Z Height
    GM0000092Courtesy of GENERAL MOTORS CORP.
  1. For vehicles equipped with a torsion bar suspension, turn the bolt (1) that contacts the torsion arm clockwise to raise, and counterclockwise to lower, the height adjustment. One revolution of the bolt into the nut increases the Z height by approximately 6 mm (0.2 in).
  2. For vehicles without torsion bars, replace damaged or worn components as necessary.
scientia non olet · About LEMON Manuals