Installation Procedure

Lubricate the steering linkage inner tie rod threads with chassis lubricant. Refer to Fluid and Lubricant Recommendations .

Fig 1: Outer Tie Rod Ball Stud & Nut

Courtesy of GENERAL MOTORS CORP.

Install the steering linkage outer tie rod (1) to the steering linkage inner tie rod.

Fig 2: Seating Idler Arm Tapers

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Use installer J 29193 to seat the steering linkage outer tie rod in the steering knuckle. See Special Tools .
Tighten: Tighten installer J 29193 to 54 N. See Special Tools .m (40 lb ft).

Fig 3: Outer Tie Rod Ball Stud & Nut

Courtesy of GENERAL MOTORS CORP.

Install the new steering linkage outer tie rod nut to the steering linkage outer tie rod (2).
Tighten: Tighten the nut to 60 N.m (44 lb ft).
Tighten the steering linkage inner tie rod nut.
Tighten: Tighten the nut to 68 N.m (50 lb ft).
Adjust the front toe. Refer to Front Toe Adjustment .