LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Steering >> Steering Linkage >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement >> Removal Procedure

Removal Procedure

  1. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
  2. Remove the steering linkage outer tie rods. Refer to Steering Linkage Outer Tie Rod Replacement .
    3. Fig 1: Inner Tie Rods Ends
    GM865341Courtesy of GENERAL MOTORS CORP.
  3. Remove the steering linkage inner tie rods (1) using wrench J 34028  (2). See Special Tools .
scientia non olet · About LEMON Manuals