LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Steering >> Steering Linkage >> Repair Instructions >> Idler Arm Replacement >> Removal Procedure

Removal Procedure

  1. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
  2. Remove the idler arm nut and discard it.
    3. NOTE: Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.
  3. Separate the idler arm from the relay rod using puller J 24319-B  .
    4. Fig 1: View Of Idler Arm
    GM793272Courtesy of GENERAL MOTORS CORP.
  4. Remove the idler arm bolts.
  5. Remove the idler arm from the vehicle.
scientia non olet · About LEMON Manuals