Noise in Steering Column
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column Description and perform the necessary inspections? | Go to Step 2 | Go to Steering Wheel and Column Description and Operation |
| 2 | Verify that noise is present in the steering column during operation. Is noise present in the steering column during operation? |
Go to Step 3 | System OK |
| 3 | Inspect the steering column mounting features for the following conditions:
Are the steering column mounting features loose? |
Go to Step 9 | Go to Step 4 |
| 4 | Inspect the SIR/SRS coil for noise. Is the SIR/SRS coil noisy? |
Go to Step 10 | Go to Step 5 |
| 5 | Inspect the lock plate retaining ring for correct installation. Is the lock plate retaining ring installed incorrectly? |
Go to Step 11 | Go to Step 6 |
| 6 | Inspect the steering column upper and lower bearings for the following conditions:
Are the bearings in need of repair or replacement? |
Go to Step 12 | Go to Step 7 |
| 7 | Inspect the tilt joint for lubrication, if equipped. Is the tilt joint lubricated? |
Go to Step 13 | Go to Step 8 |
| 8 |
IMPORTANT:
This is best evaluated while driving the vehicle, turning the steering and applying the brake pedal. Inspect the steering column intermediate shaft for noise.Is the steering column intermediate shaft noisy? |
Go to Step 14 | Go to Step 15 |
| 9 |
IMPORTANT:
If the steering column mounting feature is damaged or sheared, the steering column will need to be replaced. Refer to Steering Column Replacement . Tighten the steering column mounting fastener to specifications. Refer to Fastener Tightening Specifications .Did you complete the repair? |
Go to Step 15 | - |
| 10 | Replace the SIR/SRS coil. Refer to Inflatable Restraint Steering Wheel Module Replacement
. Did you complete the repair? |
Go to Step 15 | - |
| 11 | Install the lock plate retaining ring correctly. Did you complete the repair? |
Go to Step 15 | - |
| 12 |
IMPORTANT:
If the steering column upper and/or lower bearings are not serviceable, the steering column will need to be replaced. Refer to Steering Column Replacement . Replace the upper and/or lower bearings, if serviceable.Did you complete the replacement? |
Go to Step 15 | - |
| 13 | Lubricate the tilt joint. Did you complete the repair? |
Go to Step 15 | - |
| 14 | Replace the appropriate steering intermediate shaft component. Did you complete the repair? |
Go to Step 15 | - |
| 15 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |