LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Steering >> Power Steering >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement >> Removal Procedure

Removal Procedure

  1. Remove as much power steering fluid from the power steering reservoir as possible.
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
  3. Place drain pans under the vehicle as needed.
    4. Fig 1: View Of Power Steering Pressure Hose & Power Steering Pump
    GM898604Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the power steering gear inlet hose (2) from the power steering pump (1) and discard the O-ring seal.
    5. Fig 2: Power Steering Gear Inlet Pipe/Hose At Power Steering Gear
    GM1830857Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the power steering gear inlet hose from the steering gear and discard the O-ring seal.
  6. Remove the power steering gear inlet hose from the vehicle.
scientia non olet · About LEMON Manuals