LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Steering >> Power Steering >> Diagnostic Information and Procedures >> Whine or Growl Noise from the Power Steering System

Whine or Growl Noise from the Power Steering System

Step Action Yes No
1 Did you review the Power Steering System General Description and perform the necessary inspections? Go to Step 2  Go to Symptoms - Power Steering System 
2 Verify that a whine or growl noise is present.
Is a whine or growl noise present?
Go to Step 3  System OK
3 Inspect the power steering fluid for the following indications of contamination:
  • Milky fluid - water
  • Brown fluid - burnt
  • Debris in fluid - plastic or dirt

Was the power steering fluid contaminated?
Go to Step 4  Go to Step 4 
4 Inspect the power steering gear for a whine or growl noise using J 39570  . See Special Tools .
Is the noise present at the power steering gear?
Go to Step 8  Go to Step 5 
5 Inspect the power steering pump for a whine or growl noise using J 39570  . See Special Tools .
Is the noise present at the power steering pump?
Go to Step 9  Go to Step 6 
6 Inspect the power steering hoses for a whine or growl noise using J 39570  . See Special Tools .
Is the noise present at the power steering hoses?
Go to Step 10  Go to Step 7 
7 Inspect the hydraulic brake booster for a whine or growl noise using J 39570  . See Special Tools .
Is the noise present at the hydro boost?
Go to Step 11  Go to Step 3 
8 Replace the power steering gear. Refer to Steering Gear Replacement .
Did you complete the repair?
Go to Step 12  -
9 Replace the power steering pump. Refer to Power Steering Pump Replacement .
Did you complete the repair?
Go to Step 12  -
10 Adjust the routing of the power steering hoses.
Did you complete the repair?
Go to Step 12  -
11 Diagnose the hydraulic brake booster. Refer to Hydraulic Brake Assist System Noise Inspection .
Did you correct the condition?
Go to Step 12  -
12 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3