LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraints >> Diagnostic Information and Procedures >> DTC B0098 >> Component Testing

Component Testing

  1. Ignition OFF, disconnect the harness connector at the inflatable restraint I/P module disable switch.
  2. Test for infinite resistance between the signal circuit terminal A and the signal circuit terminal E.
    • If not the specified value, inflatable restraint I/P module disable switch.
  3. With the inflatable restraint I/P module disable switch select the OFF position.
  4. Test for 90-110 ohms between the ignition circuit terminal B and signal circuit terminal E.
    • If not the specified range, replace the inflatable restraint I/P module disable switch.
  5. With the inflatable restraint I/P module disable switch select the ON position.
  6. Test for 3.9K-3.2K ohms between the ignition circuit terminal B and signal circuit terminal A.
    • If not the specified range, replace the inflatable restraint I/P module disable switch.
scientia non olet · About LEMON Manuals