Conditions for Setting the DTC: Notes

All of the following conditions must exist for 5 seconds:

B0090 0F

• The SDM received a fault present message from the ROS.
• The ROS is in assembly plant mode and the SDM is in production mode.
• The SDM has not received any data from the ROS.

B0090 3A

• The SDM has received an ID message from the vehicle rollover sensor which does not match the ID stored in the SDM memory.
• The SDM has reset the vehicle rollover sensor twice without detecting the correct ID message.

B0090 39

• The SDM has received a Not Ok (NOK) message from the vehicle rollover sensor.
• The SDM has not received a message.