LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation, And Air Conditioning >> Repair Instructions >> Mode Door Replacement - Upper >> Removal Procedure

Removal Procedure

IMPORTANT: The upper mode door (6) is serviced with the upper HVAC module case (3).
    Fig 1: Heat Stakes On HVAC Module (Delphi)
    GM899652Courtesy of GENERAL MOTORS CORP.
  1. Remove the HVAC module. Refer to HVAC Module Assembly Replacement .
  2. Disconnect the electrical connector (3) from the mode actuator (4).
  3. Remove the screws from the mode actuator (4).
  4. Remove the mode actuator (4) from the HVAC module assembly (1).
  5. If equipped remove the heat stakes (1) from the HVAC module (2) with a screwdriver and a hammer.
    6. Fig 2: Exploded View Of HVAC Module Assembly
    GM962571Courtesy of GENERAL MOTORS CORP.
  6. If equipped remove the HVAC module assembly screws.
  7. Separate the HVAC module assembly.
  8. Remove the lever (7) from the upper mode door/upper HVAC module case (6).
scientia non olet · About LEMON Manuals