LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation, And Air Conditioning >> Repair Instructions >> Mode Door Replacement - Upper >> Installation Procedure

Installation Procedure

    Fig 1: Exploded View Of HVAC Module Assembly
    GM962571Courtesy of GENERAL MOTORS CORP.
  1. Install the lever (7) to the upper mode door/upper HVAC module case (6).
  2. Install the HVAC module assembly halves.
    3. NOTE: Refer to Fastener Notice .
    IMPORTANT: For every heat stake removed ensure that you install a screw.
  3. Install the screws to the HVAC module assembly.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  4. Install the mode actuator to the HVAC module assembly.
  5. Install the screws to the mode actuator.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  6. Connect the electrical connector to the mode actuator.
  7. Install the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
scientia non olet · About LEMON Manuals